Furman M-8DX | 15A Standard Power Conditioner with Lights and Digital Volt Meter 9 Outlets 1RU 6 Feet Cord

Furman M-8DX 15A Standard Power Conditioner with Lights and Digital Volt Meter 9 Outlets 1RU 6 Feet Cord

A MerIt'series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-8Dx into the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. The M-8Dx features two slide out, swiveling light fixtures to provide discreet illumination of your equipment on stages, in studios, and in other dark places. A dimmer knob lets you adjust the lamp brightness to just the right level.The M-8Dx also features a bright red, three-digit LED voltmeter that displays incoming voltage.

Key Features

• Noise Filtration
• 15 Amp Rating
• “Protection OK” Indicator
• Surge Protection
• 9 Total Outlets
• Wall Wart Spacing Indicator
• Front Panel Pull-Out Lights
• Digital Voltmeter

Technical Specifications

Maximum Output Current: 15 amps
Line Cord: 6 ft., captive, 14 AWG, with 3-conductor Edison plug
Lamps: Two 120V incandescent bulbs, 4 watts each
Operating Voltage: 120VAC 60Hz
Spike Protection Mode: Line to neutral
Energy Dissipation: 170 joules
Peak Impulse Current: 12,000 amps
Maximum Continuous Operating Voltage: 130 VAC RMS
Let Through Voltage (@ 125 amps, 8/20uS waveform) 400 volts
Noise Attenuation: Transverse mode: Greater than 26dB, 200Khz to 10 Mhz
Dimensions: 1.75” H x 19” W x 7.5” D
Weight:5.8 lbs.
Safety Agency Listing: cTUVus
Warranty: MerIt'series units are protected by a limited three year warranty covering defects in materials and workmanship.